The KL70 was made to work between 66 and 88MHz. So a number of challenges arose or were foreseen:
- The receiving band pass filters can't simply be re-tuned,
- The local oscillators need a substantial amount of re-work,
- The PLL loop filter may need modification, I'm yet to confirm this, and
- The transmit harmonics will require filtering.
In this post I will cover the receiver band pass filters. If you looked at my previous posts you will have noticed I'm a big fan of the Iowa Hills RF Filter Design software. Since the original bandpass filters on the receiver will not tune down to 29MHz I was forced to rebuild them.
Scouring the junkbox I found some nominal 160nH adjustable inductors. A few minutes work with the software and I had the following filter design:
My rejection of the image frequency of 72MHz is likely to be no better than 80dB for the two filters.At this point in time I didn't know about the series tuned filter transformation. The same inductors used with series LC tanks would yield around 80dB for just one 3 element filter. If you knew of local transmissions on 72MHz then I'd use one filter like that shown, and one with series LC tanks. Let me know if you want more details on this alternative filter.
After etching a board and building two filters with the same pinout as the original filter I removed the filters from the radio, disassembled them, and put my new filter into the filter housings. Prior to putting the filter in the housing they looked like this:
73's
Richard VK6TT
.
Richard.
ReplyDeleteLooking to convert kl70 to 6m as well.
Can you supply info on the process.
Cheers
Robert
VK2KGV
vk2kgv at bigpond dot com
From memory it was straightforward. Program the frequencies into an eeprom and then align. I modified two KL70's to 6m without issue. One, my spare, still sits in the cupboard. They're quite robust. Re-seat the micro a few times to clean oxidation off before putting into service and everything should be fine.
ReplyDeleteWhat part of the conversion are you struggling with?
Regards
Richard VK6TT
Haven't started as yet so just seeing what is involved. when you say program freq into eeprom, is that using the kl software, or will I have to get an eeprom burner, plus files?
DeleteCheers
Robert VK2KGV
The software generates a hex file which needs to be burnt into the eeprom. I'll email you a copy of my hex file and a listing of the frequencies I programmed into the eeprom. Might save you some typing time. I probably have a spare eeprom floating around somewhere if you get stuck.
ReplyDeleteRegards
Richard VK6TT
Richard.
ReplyDeleteDid you get around to sending hex code, plus frequencies
Robert
Hi Robert,
Deleteyes. See email dated Fri, Dec 22, 2023. Let me know if I have to resend.
Regards
Richard